HEX18GARC-KIT
QUICK REFERENCE GUIDE
Contact:
|
|
TX Panel Descriptions
1
Power Status Indicator
2
HDMI Input Status Indicator
3
HDMI Output Status Indicator
4
Power over Cable (PoC) Switch (ON / OFF) - to enable /
disable PoC being sent from the Transmitter
5
Config DIP Switch Selection - see Configuration
settings on the underside of the Transmitter
6
USB 2.0 Type A Connections - Connect to USB
peripheral devices
7
USB 2.0 Type B Connection - Connect to USB host
device
8
Ethernet Connection - Connect to network / device
for 1Gb LAN pass-through to / from Receiver
1
Power Status Indicator
2
HDMI Input Status Indicator
3
HDMI Output Status Indicator
4
Power over Cable (PoC) Switch (A / B / OFF)
- see
settings on underside of the HEX18GARC-RX
Receiver
5
Config DIP Switch Selection - see Configuration
settings on the underside of the Receiver
6
USB 2.0 Type A Connections - Connect to USB
peripheral devices
7
USB 2.0 Type B Connection - Connect to USB host
device
8
Ethernet Connection - Connect to network / device
for 1Gb LAN pass-through to / from Transmitter
4
RX Panel Descriptions
2
1
3
5
6
7
8
9
10
11
12
13
14
15
16
4
2
1
3
5
6
7
8
9
10
11
12
13
14
15
16
9
HDBaseT™ Output - Connect to HEX18GARC-RX receiver
via CAT6A cable
q
HDMI Input - Connect to HDMI source device / AVR for
eARC connectivity from HDBaseT™ Receiver
w
HDMI Output - Connect to local HDMI display
e
Optical (S/PDIF) Output - Connect to local audio
amplification or distribution device
r
L/R Output - audio breakout from receiver ARC signal
(2ch PCM only)
t
IR Output - Connect to Blustream 5V 3.5mm IR emitter
y
IR Input - Connect to Blustream 5V 3.5mm IR receiver
u
RS-232 Port - 3-Pin Phoenix connector to pass bi-
directional IR to / from the receiver
i
24V/1.25A DC Power Input 4-Pin DIN connector
17
9
HDBaseT™ Input - Connect to HEX18GARC-TX
transmitter via CAT6A cable
q
HDMI Input - Reserved for future use
w
HDMI Output - Connect to local HDMI display*
e
Optical (S/PDIF) Input - Connect to display for optical
audio return to the HEX18GARC-TX
r
IR Input - Connect to Blustream 5V 3.5mm IR receiver
t
IR Output - Connect to Blustream 5V 3.5mm IR emitter
y
RS-232 Port - 3-Pin Phoenix connector to pass bi-
directional IR to / from the transmitter
u
24V/1.25A DC Power Input 4-Pin DIN connector
*Note: HDMI output may not support Active HDMI cables
