blupura FONTEMAGNA Light, Manual

Page: 22 / 40

22
The programming button panel does not respond to the pressing of any buttons
in this phase
Press the button on the dispensing panel corresponding to the quantity to be
modified and press it again when the desired level has been reached. Repeat this
procedure for all of the quantities to be modified.
If no button is pressed within 10 seconds, the unit returns to stand-by mode.
Clock and litre-counter menu
From stand-by mode, press button 5 on the programming button panel for
around 15 seconds. The display will initially show the text PORTION PROGRAM
SELECTION IN 10 S. Continue to hold button 5 down until the following text
appears:
CLOCK SETTING
<hh>:<mm> <day>
Use buttons 1 and 2 respectively to increase and decrease the value in each field
<hh> (hours), <mm> (minutes), <day> (days of the week), and use button 5 to
move from one field to the next.
Press button 5 again to display the number of litres dispensed, sub-divided
between still water and sparkling water, and between total count and partial
count. Each time button 5 is pressed, the display will show the following values in
sequence:
• Still partial
STILL
P. <VALUE> L
It is possible to reset the partial counter by pressing buttons 3 and 4 at the same
time until the value is zero and the display shows the following text:
SERVICE RESET
• Still total
STILL
T. <VALUE> L
• Sparkling partial
SPARKLING
P. <VALUE> L
To reset the partial value, use the procedure described above.
• Sparkling total
SPARKLING
T. <VALUE> L