19
EN
INSTALLATION
1. Put the cylinder into the gas heater.
2.
Install the protection baffle to make sure the cylinder cant‘ move.
3. Connect the pipe to the gas valve with cap (make sure no leakage).
4. Connect another side of the pipe to the regulator with cap (make sure no
leakage).
5. Open the gas tap before using the heater, and close the gas tap after using.
USAGE
Lighting heater
Before connecting the regulator to the gas cylinder, check whether there is a
rubber washer on the regulator, and the washer must be in good condition.
Connect the regulator to the gas cylinder by turning the hand wheel
anticlockwise.
Open the gas cylinder by turning the gas cylinder valve anticlockwise.
Press the control knob down and hold in the pressed condition. Turn the gas
control knob on the heater to setting 1. This will allow gas to flow to the pilot
and centre burner. While holding the control knob in the pressed position,
push the piezoelectric ignition button 2 or 3 times. Each time you strike this
piezoelectric ignition you will hear a clicking sound as well as see a spark on
the pilot burner. Once the pilot has lit, continue holding the gas control knob
in the pressed position for a further 10 to 15 seconds thus activating the flame
failure safety device. The pilot and centre burner should remain alight. You
may now adjust the heater setting to Low/Med/High as required.
Turning off the heater:
To turn off the heater, turn the control knob to position 1 and close the gas
cylinder valve by turning the knob on the cylinder clockwise. Ensure that the
pilot flame the centre burner are extinguished.
Testing gas leaks:
When you suspect that the heater is leaking, turn off the gas supply and have
the unit inspected by a qualified technician. Do not attempt to locate the
source of leak with a naked flame. Locate it by sound, smell or by applying
soapy water. Any bubbles forming will indicate the whereabouts of a leak.
In event of leakage, the appliance should be turned off at the regulator switch-
on valve and the regulator disconnected from the cylinder.
