70
V1.1
SmartBus P900-TI6N USER MANUAL
L
C
D
9. The
icon will extinguish if Partition 2 is disarmed.
10. If the
or
icons remain illuminated, an error has been made while entering the
user code, press
[
]
key and re-enter the user code.
11. Once the system is disarmed, the keypad audible indicator will stop.
12. If no valid user code has been entered by the end of the
ENTRY
delay period, an
ALARM
condition will be registered and stored into the system
MEMORY.
13. If programmed to do so, the keypad will be locked and non-responsive for a
preprogrammed period for certain number of incorrect user codes, which are entered
consecutively more than the keypad lock counter (Please refer to Installer Programming
Section
– Keypad Lock Counter).
14. If the
ENTRY
delay is too short, have your installer to change the
ENTRY
delay period.
15. If the
MEMORY
indicator is flashing upon entry, there has been an intrusion. Call for
assistance. The intruder may still be inside.
Master code is a 4-digit personal identification number that allows you to enter certain
programming mode, arm or disarm the system and remotely control the system via telephone
line. In additional to Master Code, P900-T16N can be programmed to accept 14 user codes that
allow you
to arm/disarm the system. The default Master Code is “1234”.
Duress Code is an ambush code which will disarm the system and simultaneously send a silent
alarm signal to the center monitoring station. It is very useful code when you are forced to disarm
your security system under threat.
9.18
USER CODE
