08
LED SILICONE NEON FLEX
ZNSR4-10
M
Attentions before installation
Cutting marks are on the PCB and
can be seen though the product
The above diagram only shows the correct or wrong way of operation. The product should be based on the actual product.
Note:
Before installation, check that the product parameters are consistent with the requirements (Seeing product specificationsor
product labels)
Load voltage, current, power and power supply should be matched with the product.
Follow the instructions of wiring diagram (first connect the load and then the power supply) to avoid short circuit.
Make sure the correct connection of positive and negative poles between led module and power supply. Otherwise, the light will
not be on.
Make sure the power cord firmly screwed into the terminal and it should not be pulled out by hands.
The terminal should have insulation,waterproof and anti-corrosive treatment.
Attentions
Cuttable mark
Neat and smooth cut
Slide a spindle into the roll
and then place the roll with
spindle on top of the box
provided.
Correct usage of products
Gently unroll the fixture
without excessive force.
No cutting distort
No embossing operation
Do not twist
Do not repeatedly bending
This will damage the circuit
Do not wring
Do not bend 90°
No recessing operation
