07
LED SILICONE NEON FLEX
ZNSR4-10
M
Screw the aluminum track to
the installation position.
Then slowly press the tape
light into the aluminum track.
GND for negative
pole of power supply
GND for negative
pole of power supply
Wire
Sequence
VCC for positive
pole of power supply
VCC for positive
pole of power supply
DAT for data line
CLK for clock signal
The tape light is flatly and
firmly stuck on the aluminum
track.
3. Operation details of installation card
At welding part, note the positive and negative poles of lines and board and the
corresponding colors on the board; positive to positive and negative to negative
1.
1.
The controller is SP105E.
2.
SP105E supports controlling with bluetooth and mobile phone APP.
3. Bluetooth remote control distance is 20 m.
4.
SP105E can drive up to 2048 pixels.
5.
The input voltage of the controller ranges from DC 5V to DC 24V.
6.
For additional information, please refer to the SP105E Instruction Manual.
The SP105E recommended load is less than 50m;
Each connection point must use 10g silica gel, and treat waterproof and
insulation well;
2.
The screw of installation card must perpendicular to installation surface and be
fastened, as shown in the right.
3.
Note:
Note:
Controller Wiring Diagram
Lighting surface.
4.
