Pan & Tilt Unit Operation
As explained below, the ProViewer software pan/tilt controls break down into 3
groups: positioning, pre-set positions, and numeric read outs.
Positioning controls
Pan (rotate the sonar left or right) by clicking the buttons shown above.
Tilt (tip the sonar towards the surface or bottom) by clicking the buttons show
above.
Pre-defined position buttons
Clicking the ‘home’ button will cause the pan/tilt to automatically move to the
home position. The home position is factory-set to 0 degrees pan and 0 degrees
tilt. You can specify the home position under the pan/tilt section of the ‘settings’
window under the ‘file’ menu.
Clicking the ‘stow’ button will cause the pan/tilt to automatically move to the
stow position. The stow position is factory set to 0 degrees pan and 0 degrees
tilt. You can specify the stow position under the pan/tilt section of the ‘settings’
window under the ‘file’ menu.
Numeric ‘tilt’ read-out
BV-3100 User’s Handbook
15 April 2009
Page
16
