23 - Troubleshooting
Troubleshooting
Additional information
If a problem should arise, first check the following:
1. Are the connections correct?
2. Is the set being operated as described in the owner’s manual?
3. Are the other devices operating properly?
If this unit does not operate properly, check the items listed in the table
below. Should the problem persist, there may be a malfunction.
In this case, disconnect the power immediately and contact your store of
purchase.
Symptom
Solution
Only 1 Channel
Works
1. Swap speaker connections at amplifier. If
problem stays with same speaker there is a
problem with the speaker or speaker wire continue
to step 2a. If the problem moves to the other
speaker than continue to step 2b.
2a. Swap speaker connections at the speakers.
If problem moves to the other speaker then the
speaker wire is wired wrong or needs replaced. If
problem stays with the same speaker then there
is a problem with the speaker. Contact speaker
manufacturer or replace speaker.
2b. While the amplifier is cold swap the left two
tubes (three tubes on the BT-6) with the right two
tubes (three tubes on the BT-6). If the problem
switches speakers then the tubes need replaced.
Sub-woofer
sounds distorted
1. Sub-woofer is being overdriven, reduce the
gain. On the BlueTube Audio Sub-woofer the
recommended position for the gain is between
11:00 and 1:00.
Bluetooth® has
“noise” at low
volume and in
headphones at
low volume
1. Due to the nature of Bluetooth® this is an
unfortunate side effect of using the Bluetooth®
module. For optimum listening quality it is advised
to use the Aux 1 and 2 inputs.
