21
20
ENGLISH
ENGLISH
3
4
6
Picture 3
Picture 6
Picture 7
Picture 8
Picture 4
Picture 5
Wipe dry the inner pot and main heater assembly and put the inner pot into the
outer pot. Make sure no debris on the surface of the outer pot and main heater
assembly; then rotate the inner pot to the right and left slightly in order to keep
good connection between the inner pot and main heater assembly. (Picture 6)
Close the lid
Check sealing ring is properly on the inside ring of the lid.
Grasp the lid, rotate it anticlockwise to lock it with “KATA” sound. (See picture 7, 8)
7
NOTE:
a
- If cooking liquid food (soup, porridge,
etc), when the warm keeping indicator is
on, do not exhaust the air immediately,
Have to wait naturally cooling until the
floater drops, or else the liquid food will be
spouted though exhaust pipe. Putting a
wet tower on the lid will speed up cooling.
b
- Pull off the plug before opening the lid.
8
Plug in the power, turn the timer knob clockwise to choose the desired cooking
mode. The relative indicator will be on
When reach working pressure, the pressure indicator lights, entering into pressure
keeping progress, and the nixie tube shows the count-down time for pressure
keeping time. When the pressure keeping time reaches “
0
”, the cooking is finished,
and the cooker will make a sound then enter into warm keeping state
automatically, the nixie tube will show the warm keeping time.
NOTE:
a
- When the temperature of inner pot is too high, the indicator of “
Giữ ấm
” will flash.
When the temperature returns to normal, the indicator of “
Giữ ấm
” will be keep on.
b
- In warm keeping state, pull off the power if you don’t need continuous warm keeping.
For safety, after warm keeping for 12 hours, the cooker will inter into stand-by state if
there is no operation.
Open the lid and take out the food (Safety open)
Press the pressure release button at “ ” icon on the handle to exhaust the air until
out of pressure inside, then open the lid as picture
5
According to the picture
(picture 9), assemble the
pressure release valve and
check the floater dropped
(the floater should be
dropped before heating).
Picture 9
