Bluestone HOB-8735, User Manual

Page: 12 / 13

23 22
ENGLISH ENGLISH
TROUBLE SHOOTING
Fault Cause Solution
Light on, but motor
does not work
The blades are blocked Check the status of the
blades
The capacitor is damaged Replace the capacitor
The motor is damaged Replace the motor
The internal wiring of motor
is cut off/disconnected. An
unpleaseant smell may be
produced
Replace the motor
Both light and motor
do not work
Apart from the above mentioned, check the following:
Light damaged
Replace the lights
Power cord loose Connect the wires as per the
electric diagram.
Oil leakage. Outlet and the air ventilation
entrance are not sealed tightly.
Take down the outlet and
seal with glue.
Leakage from the connection
of U-shaped section and cover.
Take U-shaped section down
and seal with soap or paint.
Insufficient suction. The distance between cooker
hood and cooker top is too
large.
Readjust the distance.
Too much ventilation from
open doors or windows.
Choose a new place to install
the appliance or close some
doors and windows during
using.
The machine inclines The fixing screws are not tight
enough
Tighten the fixing screw and
make it horizontal.
The hanging screws are not
tight enough
Tighten the hanging screw
and make it horizontal.
Vibration The blade , if damaged, can
cause vibrating
Replace the blade
The motor is not tightly fastened Fasten the motor tightly
The cooker hood is not tightly
fixed.
Fixed the cooker hood tightly.
ENVIRONMENT FRIENDLY DISPOSAL
You can help protect the environment! Please remember to respect
the local regulations: hand in the non-working electrical equipments
to an appropriate waste disposal center.
Clean the Control panel surface:
- The control panel can be cleaned by using warm soapy water. Ensure the cloth is
well wrung before cleaning.
- Use a dry soft cloth to remove any excess moisture left after cleaning.
Replace the charcoal filters:
- This filter cannot be cleaned or re-used and as a general rule, the activated
charcoal filter should be changed once every three months.
- Remove the filters according to below picture.
- The charcoal filters are located at
both end of the motor. Turn the
charcoal filters until they are locked.
- The charcoal filter must be replaced
by the manufacturer, its service agent
or similarly qualified person in order
to avoid a hazard.
- If the stainless steel filter is cleaned by dishwasher, place it inside. Select the most
powerful washing program and highest temperature, maximum is 60
o
C.
- Do not use abraisive product to clean the stainless steel filters.
- After cleaning, ensure that the filters are completely dry before refitting.