Bluestone HOB-8725, User Manual

Page: 10 / 11

19 18
ENGLISH ENGLISH
TROUBLE SHOOTING
Fault Cause Solution
Light on, but motor
does not work
The blades are blocked Check the status of the
blades
The capacitor is damaged Replace the capacitor
The motor is damaged Replace the motor
The internal wiring of motor
is cut off/disconnected. An
unpleaseant smell may be
produced
Replace the motor
Both light and
motor do not work
Apart from the above mentioned, check the following:
Light damaged Replace the lights
Power cord loose Connect the wires as per
the electric diagram.
Clean the Control panel surface:
- The control panel can be cleaned by using warm soapy water. Ensure the cloth is
well wrung before cleaning.
- Use a dry soft cloth to remove any excess moisture left after cleaning.
ENVIRONMENT FRIENDLY DISPOSAL
You can help protect the environment! Please remember to respect
the local regulations: hand in the non-working electrical equipments
to an appropriate waste disposal center.
Oil leakage. Outlet and the air ventilation
entrance are not sealed
tightly.
Take down the outlet and
seal with glue.
Leakage from the
connection of U-shaped
section and cover.
Take U-shaped section
down and seal with soap
or paint.
Insufficient suction. The distance between
cooker hood and cooker top
is too large.
Readjust the distance.
Too much ventilation from
open doors or windows.
Choose a new place to
install the appliance or
close some doors and
windows during using.
The machine
inclines
The fixing screws are not
tight enough
Tighten the fixing screw
and make it horizontal.
The hanging screws are not
tight enough
Tighten the hanging screw
and make it horizontal.
Vibration
The blade , if damaged, can
cause vibrating
Replace the blade
The motor is not tightly
fastened
Fasten the motor tightly
The cooker hood is not
tightly fixed.
Fixed the cooker hood
tightly.
Replace the charcoal filters:
- This filter cannot be cleaned or re-used and as a general rule, the activated
charcoal filter should be changed once every three months.
- Remove the filters according to below
picture.
- The charcoal filters are located at both
end of the motor. Turn the charcoal filters
until they are locked.
- The charcoal filter must be replaced by
the manufacturer, its service agent or
similarly qualified person in order to
avoid a hazard.