Please make sure that you read these instructions carefully in order to avoid injury when
using the air cut off tool. Follow all health and safety rules and regulations. If in doubt and
available please contact a more knowledgeable source.
DO NOT use if damaged.
•
ALWAYS
ensure you have read through all of the instructions and fully understand how
to operate the tool before beginning.
•
ALWAYS
ensure the air cut off tool and cutting wheels have been checked for any
damage before use. Any damage found needs to be repaired or replaced before use to
prevent damage to property or personal injury.
•
ALWAYS
ensure the air hose has been checked for any damage before use. Any damage
found needs to be repaired or replaced before use to prevent damage to property or
personal injury.
•
ALWAYS
ensure the air hose is kept away from heat and any sharp edges.
•
DO NOT
carry the tool by the air hose.
•
ALWAYS
ensure the air hose does not cause a trip hazard when in use.
•
ALWAYS
ensure the correct and approved eye and face protection is used when
operating the tool.
• If noise levels exceed safe levels wear approved ear protectors.
•
ALWAYS
ensure gloves and protective clothing are worn. Gloves should be tight fitting
with no hanging threads. Do not wear loose clothing.
• Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip
shoes.
• Ensure any long hair is tied back and jewellery is removed before operating the tool.
•
ALWAYS
ensure your hands and body are kept away from the working area of the tool.
• Maintain tool in good and clean condition for best and safest performance. For safest
performance ensure the tool is kept clean and is lubricated.
• Only use the recommended accessories for the air cut off tool.
02
Safe use
(continued)
• Keep the work area clean, uncluttered and ensure there is adequate lighting.
• Keep children and unauthorised persons away from the work area.
• Before connecting the air cut off tool to the air supply make sure the tool is switched
off and your finger is not on the trigger.
• Only use air tool oil to lubricate the tool.
•
BE AWARE
that constant vibration can be harmful to hands and arms. Take frequent
breaks.
•
ALWAYS
ensure the parts on the air cut off tool including the wheel are secure before
operation.
•
ALWAYS
ensure the workpiece you will be working on is secure so you don’t have to
hold the workpiece while operating the tool.
•
ALWAYS
ensure your hands are kept away from the wheel and guard during operation.
•
ALWAYS
be careful when working with compressed air as it can be dangerous.
•
DO NOT
operate the air tool continually at full throttle without a work load on the tool.
•
ALWAYS
ensure the air tool is lubricated correctly before operation.
•
DO NOT
operate the air tool without the guards in place.
•
DO NOT
modify the tool.
•
DO NOT
operate the air tool whilst tired or under the influence of drugs, alcohol or any
medication.
•
BE AWARE
excessive air pressure may decrease the life of the tool and cause a
hazardous situation.
•
NEVER
use the air tool near flammable objects or in explosive environments.
•
DO NOT
use the air tool near live electrical wires.
•
DO NOT
use the air cut off tool in damp or wet conditions.
•
NEVER
leave the air cut off tool unattended. When the tool is not in use it should be
disconnected from the air source and stored correctly out of the reach of children.
•
ALWAYS
ensure air supply has been shut off and any pressure from the tool has been
discharged before removing the hose or storing the tool.
•
DO NOT
use combustible gases, carbon dioxide, oxygen or bottled gas with the air cut
off tool.
•
NEVER
use the air cut off tool to perform a task it was not designed to do.
• If the air cut off tool is damaged do not use.
