v1.7 - Jun 2019
18 |
P a g e
Reset Hardware Defaults
If you really screw up the settings, and for some reason you cannot fix them through the serial
connection, then it is possible to reset the hardware settings to their default values using the
procedure shown below. You might have to do this if the bluetoothWaitTime gets set to less than
the amount of time required to establish a connection.
For v10 and earlier hardware if programming pad 4 (the forth pad from the arrow which indicates
pad 1) is high when the device is turned on, then the reset to default sequence will be entered. Pad
2 is the positive voltage signal so shorting pads 2 and 4, then powering on the device, will achieve
hardware reset.
