Blueair Cabin P2i, User Manual

Page: 16 / 38

16
x 3 sec
Flick the control knob
counterclockwise and
hold for 3 seconds until
the lights are turned off.
8. Notifications
7. Idle mode
3 red LEDs blink in a
triangle formation
should a notification or
error occur (see table
below).
SITUATION RECOMMENDED ACTION
Unit is not working - unit is disconnected from
the control plug.
Check that control knob is correctly installed
and that the cable/connector is not damaged.
Unit is not working - USB charging port overload.
If the USB charging port is powering a device that
draws too much power, the system may shut
down.
Remove external device from USB charging
port.
General hardware failure Contact customer service
Other error not indicated by error code. The
LEDs on the control knob do not light up even
though the unit is functioning.
Contact customer service