Blueair BSF23, Installation & Operation Manual

Page: 5 / 16

1. CLEANING THE INTERIOR AND EXTERIOR
- The interior and exterior of the unit can be cleaned using warm water with soap.
- Do not use an abrasive cleaner because it will scratch the surface.
2. CLEANING THE GASKET
- The door gasket should be cleaned frequently to maintain proper sealing.
Use warm water and a mild soap.
3. CLEANING THE EVAPORATOR
- If you need to clean the evaporator, please contact the qualified service technicians.
4. CHECK AFTER CLEANING
- Check the unit again for safety.
- Check if the unit is operating properly.
ᵀ aŒ’@f•Žƒ”‰ŽOr ‰Ž„ ’@†’@ ’‰„‰ƒ@cŽ„ Ž“ ’@cŒ Ž‰Ž‡
A reminder alarm will sound on the unit to remind the customer to clean the condenser every 6 months.
Warning
Accumulated dust build up on the condenser fin can cause the unit to malfunction and compressor overload
To remind the customer to clean the unit’s condenser
The unit’s buzzer will sound and the unit will blink “CL” on the display panel
To reset the alarm
Press “
ᵋ
” & ”
ᵍ
“ buttons at the same time and hold for 3 seconds. The unit’s buzzer will stop and “CL” will
disappear and the unit’s temperature will display on the display panel.
If the reminder alarm is not reset
The unit’s buzzer will sound for one hour and automatically turn off
The unit’s display will continuously display a blinking “CL”
Cleaning
WARNING - To reduce the risk of electric shock, unplug before
cleaning or servicing.