Blueair BSF23, Installation & Operation Manual

Page: 4 / 16

1. GOOD AIR CIRCULATION
- Make sure to avoid any object which will interrupt or block the air flow inside the unit.
- Make sure to leave enough space toward the interior rear wall to ensure good air circulation
- Make sure to keep 5 inch space between the back of the unit and the wall.
2. PLACE ON STRONG GROUND
- Place the unit on a floor strong enough to hold
3. DO NOT PLACE NEAR HEAT SOURCE
- Make sure to avoid hot corner or any location near stove, oven, or other heat source.
- High ambient temperature will cause cooling efficiency to drop.
4. INDOOR USAGE ONLY
- This equipment is intended for indoor use only.
5. STABILIZING
- Make sure the unit is installed in a stable condition with the front wheels locked while in use.
6. LEVELING
- Make sure that the unit is leveled well from front to back and side to side.
7. Unit should be connected to a dedicated electrical circuit.
- Do not use extension cords.
- Plug the unit to a dedicated electrical circuit & adequate capacity.
8. Install plastic condensate pan in the bottom of the unit.
- Make sure pads are installed upwards and drain hose is in pan.
9. Install the unit in a place where the air circulation is good.
- Maintain enough spaces around the unit since air
to ensure the best cooling performance
- If air circulation is obstructed, then cooling
performance will drop, thus consuming more electricity as a result.
Reference
If a left-hinge door is needed, please contact the sales representative in your area.
A set of door hinge can be purchased separately to
convert between right -hinge door and left-hinge door.
Installation
over 1 ft
over 7 inches over 7 inches