ASSEMBLING THE POOL RAIL
Unpack all the components and check the parts against the checklist
IMPORTANT:
Leave about 0.4-inch (1 cm) gap between
the 2 ends of the Bottom Rail.
(Diagram 4)
(Diagram 5)
Place the metal plates equally around the circle (See diagram 4)
Slide the resin bottom rail into the metal foot plate (See diagram 5). Repeat this process for all bottom rails.
It is recommended that you place 2-inch patio block under each foot plate. If you decide to use patio blocks under the foot
plates you must dig them into the dirt, so the bottom rails lay flush on the dirt.
(Diagram 6)
You can make fine adjustment to the bottom rail’s diameter.
When all the rails are slide into the metal plates, it should form a complete circle and the diameter should be equivalent to
the diameter of the pool itself. You can shorten or lengthen the gap distance between the 2 ends of Bottom Rails. (See
diagram 6)