STEP 8
Testing
I
f you haven’t already added water to the
Fountain Basin, add water until the basin is full
(to the bottom of the grates). Plug in the pump
cord to test your fountain.
Set the water flow and plume height by
adjusting the valves with the provided red valve
key. Use the included plastic shims to level the
fountains for even water flow over the columns.
If the height of the plumes is still lacking, use
the 3 pieces of 1” x
3/4
” clear vinyl and insert
them into the ends of the fountain hoses. This
will increase the height of the water plumes.
Splash should be kept to a minimum to avoid
excessive refilling. Our optional AutoFill Kit,
shown after Step 3, is used to keep the water
level topped off.
8
8
Low water plume
High water plume
STEP 7
Fountain Setup
Bring one of the columns to the basin and feed
correct length of tubing through the bottom
of the column until the end of the hose gets
within 1-2” of the top.
Carefully stand the column up, making sure the
hose is not pinched underneath. Excess hose
may be fed back into the basin. Repeat with
the remaining columns.
7
7