Stereo Monitoring System
USER MANUAL • 6 • A tour of the eXo
2
amplifier and Remote
User Manual • A Tour of the eXo
2
Amplifier and Remote • Page 7
2
1.
SPEAKER OUTPUTS - These are high quality binding posts that
are compatible with both bare speaker wire and other speaker
connectors (such as spades and signle banana plugs). Please
always maintain proper phase and be careful to avoid short-
circuits between output terminals.
2.
REMOTE / PREAMP INPUT: Turn off power when connecting
or disconnecting the remote / pre-amp from the back of the
subwoofer.
3.
POWER SWITCH - Controls the power to all the three amplifiers
and all internal electronics.
5.
IEC 320 Receptacle, with detachable power cord and integral
fuse holder. Replace fuse with same rating and type listed on the
back panel. 115V applications use a 5 x 20mm, T 2 Amp 250V
(time delay). 230V applications use a 5 x 20mm, T 1 Amp 250V
(time delay).
1.
REMOTE / PREAMP CONNECTOR - This connector is used with
the included multi pin cable, which connects the remote to the
subwoofer. Turn off power when connecting or disconnecting the
remote / pre-amp from the back of the subwoofer.
2.
LEFT XLR / TRS ‘COMBO’ INPUT (ELECTRONICALLY BALANCED):
This LEFT XLR / TRS input should be connected to the Left output
of your console or digital workstation. This input is electronically
balanced. Do not connect more than one source to this input.
Refer to page 6 for more information [System Signal Connection
and Level Setting]
3.
LEFT and RIGHT RCA IN - These are unbalanced RCA type inputs
that are designed to work with -10 dBV sources, such as consumer
sound cards, CD players, some mixers, etc. Refer to page 6 for
more information [System Signal Connection and Level Setting].
4.
RIGHT XLR / TRS ‘COMBO’ INPUT (ELECTRONICALLY BALANCED):
This RIGHT XLR / TRS input should be connected to the Right
output of your console or digital workstation. This input is
electronically balanced. Do not connect more than one source to
this input. Refer to page 6 for more information [System Signal
Connection and Level Setting]
continued on page 8
Please note that all inputs can be used simultaneously.
1
2
3
4
2
3
4
1
