Stereo Monitoring System
USER MANUAL • 10 • Technical Information
User Manual • Technical Information • Page 11
This next section outlines the components, specifications and performance
data that make this product such a uniquely high value.
In order to continually improve all of its products, Blue Sky reserves the right
to change these specifications without notice.
eXo
2
Specifications
General Specifications
Input Impedance
XLR / TRS Combo
60k Ohms balanced Input gain = +0dBu
RCA input:
30k Ohms unbalanced
3.5mm (front panel input)
15k Ohms unbalanced
Common Mode Rejection Ratio
40 dB typical @ 60Hz
(balanced inputs only)
Maximum Input Level
+18 dBu XLR / TRS/ RCA
Input gain = +0dBu
+12 dBu 3.5mm / Mini-Jack (front panel input)
Voltage Sensitivity
200mV = 90 dB SPL @ 1m XLR/TRS
(input gain = 0dBu)
200mV = 90 dB SPL @ 1m RCA
200mV = 96 dB SPL @ 1m 3.5mm
(front panel input)
Note: 200mV = -11.75 dBu = -14 dBV
Amplifier power output Note: All power output measurements made with
the speaker protection circuits disabled. Long term power output is limited
by the speaker protection circuitry.
Short term power output 1 channel driven:
42 watts x 1 @ <.1% THD into 4 ohms @ 1 kHz
Short term power output 2 channels driven :
35 watts x 2 @ <.1% THD into 4 ohms @ 1 kHz
Subwoofer power output:
110 watts x 1 @ <1% THD into 4 ohms @ 50 HZ
3.5mm headphone output:
4 mW x 2 @ <.2% THD into 16 ohms @ 1 kHz
Mains voltages:
115V / 60Hz (North American Version)
230V / 50Hz (Export)
Voltage is set at the factory
Maximum power consumption:
240 watts
Fuse Type and Rating:
115V = 5 x 20mm, T 2 Amp 250V
(Time Delay)
.
230V = 5 x 20mm, T 1 Amp 250V
(Time Delay)
Satellite
• The single 1/4” X 20 insert on the back of the eXo
2
SAT is
compatible with BT Technologies BT-33 Brackets (www.btech-usa.com)
and is also compatible with OmniMount’s type 10 Series of wall / ceiling
brackets (www.omnimount.com). For more details on this mounting insert
please see page 12 [Satellite Cabinet Dimensions]
• Dimensions:
7.2” H X 4.8” D x 5” W
18.1 cm X 12.1 cm x 12.7 cm
• Weight 3 lbs. / 1.36 kg
• 3” cast frame woofer, Neodymium motor structure
• 1” fabric Neodymium tweeter
• Fully Video Shielded
• Satellite Low frequency crossover
140 Hz
• Tweeter Crossover Frequency
2200 Hz
• Nominal SAT impedance
4 Ohms
The following specifications are measured using the eXo
2
Amplifier
• Frequency Response Satellite
+/- 2.0 dB 200 Hz to 10 kHz
+/- 3.0 dB 140 Hz to 20 kHz
8” Sealed Box Subwoofer
• 8” woofer, vented motor, paper cone with foam surround
• Fully video shielded,
• Isolation feet are included
• Dimensions:
(subwoofer only)
9.4” H x 9” W x 10.2” D
2
3
.9
cm x
22.9
cm x
25.9
cm
• Weight 20 lbs. / 9.07kg
• Frequency Response Subwoofer
Anechoic Response:
35 to 140 Hz +/-6dB
Typical In-Room Response:
20 to 200 Hz (1500 Cubic Feet)
2
