-10-
Revision 3/F3601
3.1.3 OVEN
1) Open oven doors. Push in thermostat
knob and rotate anti-clockwise to the
PILOT ( ) position.
2) Hold in the thermostat knob.
3) With the thermostat knob held in, light the
pilot burner by pressing the piezo button.
View the lit pilot burner through the
inspection hole.
4) Release knob approximately 10 seconds
after lighting pilot.
5) Pilot should now remain alight - if not,
repeat steps 2 to 4.
6) The oven temperature can now be set by
rotating the control knob anticlockwise to
any position from the 1 - 7 markings. The
control knob requires to be slightly
depressed when starting from the pilot
position, however once out of the pilot
position it can be freely turned up or
down.
See the temperature conversion chart
below for oven centre temperatures
obtained at the gas mark settings 1 - 7.
3. OPERATION
NOTE:
A full user’s operation manual is supplied with the product and can be used for further
referencing of installation, operation and service.
3.1.1 HOB OPEN BURNERS
Flame Failure Protection is incorporated by
way of a thermo-electric system for each
burner which will shut off the gas supply to
that burner in the event that the burner goes
out, so that raw gas is not expelled.
1) Select the burner, depress and turn the
corresponding knob anti-clockwise to full
position ( ).
2) With control knob depressed, light burner.
3) Release knob approximately 10-20
seconds after lighting burner.
4) Burner should stay alight - if not, repeat
Steps 2-3.
5) The burner can now be operated. At this
position it is full ( ).
6) To achieve simmer control, depress knob
and rotate fully anti-clockwise. Or operate
between full ( ) and low ( ) positions.
7) When main burner is not required, turn
knob clockwise back to the off position.
3.1.2
GRIDDLES
1) Depress the control knob and rotate anti-
clockwise to the pilot ( ) position.
2) With the control knob depressed, press
the piezo button to ignite the pilot burner.
Repeat until lit.
3) Release knob approximately 10 seconds
after lighting pilot.
4) Pilot should now remain alight - if not,
repeat steps 2 to 4.
5) Full flame can now be achieved by
rotating control anti-clockwise to the first
stop ( ).
6) Low flame can be achieved by depressing
the control knob and rotating fully anti-
clockwise ( ).
3.1 OPERATION
Gas Mark 1
2
3
4
5
6
7
Temp °C 100 130 160 190 225 260 290