Cleaning and Maintenance
18
Fig 5
Burner Base
Trivets and Burners
a. Remove the trivets from the top of the appliance,
taking note that the trivets are manufactured with a
lip on one edge, the lip must always be fitted to the
outer edge (front and back) of the cook top. (Refer
to Fig 10 overleaf).
b. Remove the burner cap and burner bowl (these are a
loose fit to the manifold, see Fig 5) from the top of
the gas manifold, taking care not to damage the
thermocouple (and pilot tube for -PF Option) fitted
through the manifold splash guard. (Refer to Fig 8
for F Option and Fig 9 for PF Option).
c. The trivets and burners should be cleaned with a mild
detergent and hot water solution using a soft bristled
brush. Dry thoroughly with a dry cloth.
Trivet Supports
a. Remove all the trivet supports from the top of the
appliance. Take note of the orientation of the trivet
support when removing. The trivet support front end
side rail profiles are different from the rear end side
rail profiles.
(See the Note shown at Item a in
‘Re-Fitting the Components to the Range’ overleaf
and Fig 6).
b. The trivet supports should be cleaned with a mild
detergent and hot water solution using a soft bristled
brush.
c. Dry the trivet supports thoroughly with a dry cloth.
Stainless Steel Surfaces
a. With the griddle plates and burners removed, clean
the interior and exterior surfaces of the range with
hot water, a mild detergent solution and a soft
scrubbing brush. Note that the gas control knobs are
a push fit onto the gas control valve spindles and can
be removed to allow cleaning of the front of the
control panel.
b. Baked on deposits or discolouration may require a
good quality stainless steel cleaner or stainless steel
wool. Always apply cleaner when the appliance is
cold and rub in the direction of the grain.
c. It should not be necessary to remove the splash
guards covering the burner manifolds for cleaning
purposes. These can be cleaned in situ.
d. Dry all components thoroughly with a dry cloth and
polish with a soft dry cloth.
e. To remove any discolouration, use an approved
stainless steel cleaner or stainless steel wool. Always
rub in the direction of the grain.
f. Remove the grease tray and clean with a mild anti
bacterial detergent and hot water solution using a
soft bristled brush.
g. Dry the grease tray thoroughly with a dry cloth.
h.
Dry all components thoroughly with a dry cloth and
polish with a soft dry cloth.
Re-Fitting the Components to the Range
a. Refit the trivet supports to the range, ensuring that the
trivet supports are correctly fitted.
Burner Bowl
Locating Holes
Fig 7
Notice Difference
in Profiles
Fig 6
Fig 5
Burner Bowl
Burner Cap
Burner Base Locates onto
Cap Screw and over Flange
Fig 8
F - Option
Fig 9
Shown without Pilot
Burner Shield fitted.
Pilot Burner
Thermocouple
PF - Option
