Blue Seal Evolution G504, Installation And Operation Manual

Page: 18 / 31

16
Trivets and Burners
a. Remove the trivets from the top of the appliance, taking
note that the trivets are manufactured with a lip on one
edge, the lip must always be fitted to the outer edge
(front and back) of the range. (See Fig 10).
b. Remove the burner cap and burner bowl (these are a
loose fit to the manifold, see Fig 5) from the top of the
gas manifold, taking care not to damage the
thermocouple (and pilot tube - PF Option) fitted through
the manifold splash guard. (Refer to Fig 8 for 'F' Option
and Fig 9 for 'PF' Option).
c. The trivets and burners should be cleaned with a mild
detergent and hot water solution using a soft bristled
brush. Dry thoroughly with a dry cloth.
Trivet Supports
a. Remove all the trivet supports from the top of the
appliance. Note the orientation of the trivet support
when removing. The trivet support front end side rail
profiles are different from the rear end side rail profiles.
(See the Note shown at Item a, in ‘Re-Fitting the
Components to the Range’ on the following page and
Fig 6).
b. The trivet supports should be cleaned with a mild
detergent and hot water solution using a soft bristled
brush.
c. Dry the trivet supports thoroughly with a dry cloth.
Stainless Steel Surfaces
a. With the griddle plates and burners removed, clean the
interior and exterior surfaces of the range with hot
water, a mild detergent solution and a soft scrubbing
brush. Note that the gas control knobs are a push fit
onto the gas control valve spindles and can be removed
to allow cleaning of the front control panel.
b. Baked on deposits or discolouration may require a good
quality stainless steel cleaner or stainless steel wool.
Always apply cleaner when the appliance is cold and rub
in the direction of the grain.
c. It should not be necessary to remove the splash guards
covering the burner manifolds for cleaning purposes.
These can be cleaned in situ.
d. Dry all components thoroughly with a dry cloth and
polish with a soft dry cloth.
e. To remove any discolouration, use an approved stainless
steel cleaner or stainless steel wool. Always rub in the
direction of the grain.
f. Remove the grease tray and clean with a mild anti
bacterial detergent and hot water solution using a soft
bristled brush.
g. Dry the grease tray thoroughly with a dry cloth.
h. Dry all components thoroughly with a dry cloth and
polish with a soft dry cloth.
Re-Fitting the Components to the Range
a. Refit the trivet supports to the range, ensuring that these
are correctly fitted.
Cleaning and Maintenance
Fig 5
Burner Bowl
Locating Holes
Fig 7
Notice Difference
in Profiles
Fig 6
Fig 5
Burner Bowl
Burner Cap
Burner Base Locates onto
Cap Screw and over Flange
Fig 8
F - Option
Fig 9
Shown without Pilot
Burner Shield fitted.
Pilot Burner
Thermocouple
PF - Option