background image

LIMITED WARRANTY STATEMENT

Snap-on Tools warrants this product to be free from defects in material and workmanship for 
a period of  1  year from date of purchase. This warranty applies to the original purchaser 
(end user) only and is not transferable. Damaged components and assemblies i.e. bent 
ram and pump pistons, dented reservoirs, cracked or altered components, are the result of 
mis-use, mis-application or a combination of both. These conditions will not be considered 
for warranty credit. We have complete confidence that the Snap-on product you purchase 
will meet or exceed your performance requirement. However in the unlikely event that a 
Snap-on product fails due to material or workmanship defect within the warranty period you 
may contact your retailer for disposition or you may contact an Authorized Service Center 
listed in the product owner’s manual. Except where such limitations and exclusions are 
specifically prohibited by law, the consumer’s sole and exclusive remedy shall be the repair 
or replacement of the defective product. Snap-on shall not be liable for any consequential 
or incidental damage or loss whatsoever, and the duration of any and all expressed and 
implied warranties, including without limitation, any warranties of merchantability and fitness 
for a particular purpose, is limited to a period of  1 year from date of purchase. Some 
States do not allow the exclusion or limitation of incidental or consequential damages, so 
the above may not apply to you. This warranty gives you specific legal rights. You may 
also have other rights which vary from state to state.

Manufactured for Snap-on Tools Company

2801 80

th

 Street  Kenosha, WI 53141-1410

Made in China

8

Summary of Contents for YA1544A








Reviews: