6
Attaching the grinder to the Prime Mover
NOTE
Before attempting to attach the
g
rinder to the
prime mover, verify that all hydraulic
couplers are compatible.
CAUTION
Hydraulics should operate in an even and
smooth manner. Hydraulic movement that is
not even and smooth may indicate that air is
in the hydraulic lines.
WARNING
Improper attachment to the prime mover may
cause personal injury.
CAUTION
All hydraulic connections must be clean and
free of debris before making any connection.
WARNING
Improper disconnection may result in
personal injury or damage to the attachment
and prime mover.
CAUTION
All hydraulic connections must be clean and
free of debris before disconnection
NOTE
Hydraulic connections must be disconnected
before disengaging latches to prevent damage
to the prime mover or the attachment.
1.
Place the
g
rinder attachment on a level surface.
2.
Position and align the prime mover to the rear of the
attachment, within proximity of the front of prime mover.
3.
Insert and connect the prime mover into the attachment.
4.
Connect the hydraulic lines from the attachment to the prime
mover.
5.
Close latches (or other locking mechanism) to secure the
attachment to the prime mover.
6.
Using the prime mover with the
Multifunction
controller and
harness, raise the attachment and move the attachment to
ensure hydraulic lines are clear of air and operate properly.
7.
Lower the attachment to ground level.
8.
Route hoses away from pinch areas – install cable ties if
necessary to assure extended hose life.
9.
Inspect that the attachment is mounted properly and securely.
If the attachment does not meet this requirement, follow the
instructions to remove the
g
rinder and re-attach using
the
instructions above.
1. Using the prime mover, lower the attachment to the
ground.
2. Relieve the pressure in the hydraulic system by
following these instructions:
a. Turn the ignition to off.
b. Turn the ignition back to the on position without
starting the machine.
c. Move the auxiliary hydraulic function lever back
and forth to relieve the pressure in the hydraulic lines
(this will greatly assist you when hooking the unit
back up so that the hydraulic couplers connect easily).
3. Disconnect the hydraulic connection between the
attachment and the prime mover. To prevent
contamination, remove any dirt and debris from the
couplers.
4.
Disengage the prime mover latches (or other locking
mechanism) from the attachment.
5. Remove the prime mover from the attachment.
Remov
i
ng the
grinder
from the Prime Mover
