7
ASSEMBLY INSTRUCTIONS
3
A
D
4
D
J
Connect the other end of high pressure hose (D) to
spray gun (J) by inserting the brass metal tip of high
pressure hose into the fitting just ahead of trigger
guard. It will lock into spray gun with a “click”. Confirm
hose is locked into spray gun by slightly pulling on them.
The hose is now securely attached to spray gun.
Note: DO NOT
press button on underside of gun when
connecting hose to gun.
High Pressure Hose Assembly
Screw high pressure hose (D) clockwise onto bottom
left, when facing the unit, front of pressure washer
unit (A). Pull back collar and insert o-ring post into
water outlet far enough so collar can thread onto outlet
threads until hand tight. If it takes fewer than six turns
you have not properly tightened the high pressure
hose fitting. It is easier to position the pressure washer
in front of you to ensure that the threads are started
correctly. Failure to properly tighten high pressure
hose will result in the hose slipping or popping off
immediately upon turning unit on. Do not worry about
damage if this occurs–just reinstall and take extra care
when screwing on the high pressure hose fitting.
Note: DO NOT
use pliers or locking pliers to tighten.
2
1
5
D
J
To release hose (D) from spray gun (J), press button on
underside of gun toward trigger guard. The hose will
slide out from connection.
