2017-12
1 866 907 0122 blubathworks.com
3
Installation Instructions for Wall-mount Toilet
LW6020A · LW6030A
1
Y
Y
1
2
X
X
+
1/8
"
+(3 mm)
1
Water inlet pipe
Water outlet pipe
1
1
2
2
Insert discharge pipe into the pipe hub in the wall. Place a
straight edge flush against the wall and mark a line on the
pipe. Fit finned rubber seal onto flush pipe. Repeat same
procedure for discharge pipe.
Place discharge pipe with gasket into waste outlet of bowl.
Also place flush pipe with fin gasket into inlet of bowl. Then
mark a second line on both pipes.
Add dimension X and
8
". Using that dimension, mark a line on
the pipe measuring from the hub side. Cut off the pipe at the line
with a pipe cutter.
Add dimension Y and
8
". Using that dimension, mark a line on
the pipe measuring from the hub side. Cut off the pipe at the line
with a pipe cutter.
Bevel the sharp edges as shown to ensure a smooth
insertion into the pipe hubs in the wall.
2
nut
mounting fittings
from the flat surface to the top
Connecting bolt
Bearing bolt
Installation hole
1
s
"
e
"
provided with the toilet
provided with wall carrier
a). Use hexagonal key to screw the
conical nut into mounting fittings.
+
1/8
"
+(3 mm)
2
Decide the Size of Drainage Pipe
Install the connecting bolt
b). Insert the auxiliary part into the aiming
screw by pushing the part tothe top from
its flat surface.
c). the auxiliary part is totally inserted into
the aiming screw.
d). Put the mounting fittings into the installation hole on toilet.
e). Turn the toilet and make the installation hole vertically
upside.The leg side of screw should lock the fixed position
on back side of toilet.
f). Adjust the position of bearing bolt well and screw it into
the connecting bolt
⅛
⅛
