Step 5.2
To install the EZ Anchors™ (E), gently tap or press the tip into the drywall and slowly screw the
anchors into the wall, as shown in Fig 5.1 A. Make sure the flat side of the anchor is flush with the
wall. Do not over-tighten the anchors as this will render them ineffective, as well as damage the
drywall. If you encounter a wall stud while installing an EZ Anchor™ (E), use the mounting screw
without the anchor. We only suggest using the provided EZ Anchors™ since each one has a weight
capacity of up to 50 pounds. Plastic anchors are not an acceptable substitute.
Step 5.3
Install the Wall Bracket (H) using the 3 x 1” screws provided. A correctly installed Wall Bracket (H)
is illustrated in Fig 5.3 A & 5.3 B
Fig 5.3 A
Fig 6.1 A
Fig 6.2 A – 6.2 B
Fig 5.1 A
Fig 5.3 B
Section
6
–
Operating
your
Fountain
Step 6.1
Unwind the Water Pump (A) and LED Light (C) power cords and run
the cord for the light up and over the back of the reservoir from
behind the mirror. The cord for the LED Light (C) should be behind
the bracket and sitting in the cut out at the top of the fountain, as
shown in Fig 6.1 A.
Step 6.2
Lift your waterfall into place and engage the
bracket on the back of the fountain by
lowering it onto the Wall Bracket (H), as
shown in Fig 6.2 A & 6.2 B.
