6
Seat Bolt
Rubber Brushing
Nut
5
6. INSTALL THE TOILET
Install the toilet tank lid onto the toilet tank top.
7. INSTALL THE TOILET SEAT
Install the toilet seat onto the toilet bowl (see Fig 5). (Top Mount Bolt Set is included with the bowl). Insert the
rubber bushing nuts into the bowl seat holes.
Note:
Remove the existing seat if necessary. Place the seat on the bowl and rotate the hinge unit into place while
holding seat down on the bowl. Fasten and tighten the bolt from the top with a screwdriver. Replace the bolt cap
and the lower lid (if necessary).
Toilet Tank Fill Valve Instruction
Note:
Fill Valve Height has been preset at the factory and DOES NOT require any height adjustment
INSTALLATION
1. Shut off the water supply to the toilet.
2. Flush toilet and remove remaining water from tank with a sponge.
3. Remove the water supply connection at the fill valve.
4. Remove old fill valve and use damp sponge to clean hole in tank.
5. Place new fill valve inside tank hole.
6. Thread mounting nut onto fill valve shank and tighten the nut.
Note:
Do not over-tighten. Be sure to install fill valve in a position that does not interfere with the trip lever
operation.
7. Connect water supply to fill valve shank and hand-tighten only.
Note:
Do not overtighten. These are plastic parts. Never use pipe dope on any water supply connection.
8. Attach refill tube to fill valve nipple and clip other end of refill tube to the overflow pipe.
9. T urn water supply ON and check for leaks outside the tank.
Note
: As water fills the tank, water is also directed into the overflow tube via the refill tube. This additional flow
of water is critical to refilling your toilet’s bowl. Once the water stops filling the tank, some residual drops of
water may drip from the fill valve. This is NORMAL as these drops will subside.
