11
eng
key). Make sure the end stays are assembled
correct side up. (refer to illustration 14)
WARNING
To prevent injury from falls, the crib shall no
longer be used if child is able to climb out of crib.
Consider converting to toddler bed mode with
the optional bed.
Toddler Bed Set Up
Optional bed rail is available as accessory.
Please check with your retailer or
bloombaby.com for more details.
17
-
18
Castors Assembly
– 4 lockable castors are included. The use of
these is optional.
– If you choose to use castors with your
crib, always lock the brakes of the castors
whenever the crib is in use.
– (#09 castors) Attach the castors by screwing
them into the threaded holes by turning the
hex blot until tight.
– To lock castors, push down on the locking
levers on each castor.
– To unlock, lift up the levers on each castor.
– To remove castors, turn hex blot to unscrew
loose.
19
-
20
Storage
– To fold away your alma papa crib for storage,
first remove mattress.
– Remove base board from frame - loosening
the bolts on both end of the bed base.
with tool included (hex key). Make sure the
sides with stays assembled faces to the inside
of the crib. (refer to illustration 3)
– Assemble the other end panel by tightening
the bolts with tool included (hex key). (refer to
illustration 4)
– (#07 tool – hex key, #10 long bolts) Tightening
the end panels’ posts using the long
bolts with tool included (hex key). (refer to
illustration 5)
– (#06 cross bar) Place the cross bar onto the
troughs that are located at the bottom of side
panels. Make sure tips of on cross bar should
be go downward into the troughs. (refer to
illustration 6)
– (#03 base board) Place the base board within
the crib, onto the stays. Make sure correct
side up – the side with labels is the top side of
base board.
– Assemble the bed base onto end stays on
both end panels by tightening the bolts with
tool included (hex key).
– Please store the tool (hex key) in safe place for
future use.
– The crib assembly is now complete.
11
-
16
To change base board level to LOWER
position
– (#04a & b side stays, #05 end stays) Remove
all 6 base board stays from the frame (side
stays x 4 + end stays x 2) by loosening the
bolts with tool included (hex key).
– Assemble the 6 base board stays to your
desired base board level. Secure by
tightening the bolts with tool included (hex
