32
1. If not already attached, manually
screw the bent end of the supply hose
tightly onto the rear panel of the ma-
chine (not in case of A).
2. Screw the Aquasafe or A (de-
pending on the model) at the end of
the supply hose tightly onto the water
tap by hand.
3
The Aquasafe or A (depend-
ing on model) turns off the water sup-
ply should a leakage occur in your
hose.
3. Turn the water tap all the way on and
check all connections for leaks; Turn
the water tap off again. Correct the
position of seals and screw couplings,
if necessary.
Connecting the water drain
You can hang the drain hose over the edge
of a wash basin, sink or bathtub – or con-
nect it permanently to a drain pipe (siphon
trap).
Important:
• Do not run the drain hose higher than
100 cm above floor level for the suds
pump to be able to pump out. Don't
go below the minimal height of
40 cm, otherwise water will come out.
.
• The water must be able to run off un-
hindered. Washbasins with a small
drain are not suitable.
• The end of the hose must not im-
merge in the pumped-out water.
• Check with customer service for hose
extensions. Do not use homemade ex-
tensions with hose clamps or similar!
• Use only the new hose supplied with
the machine, not an old existing one!
• Ensure that there are no sharp bends
in the hose!
