![background image](http://html1.mh-extra.com/html/blomberg/kgm-9691/kgm-9691_operating-instructions-manual_2774011015.webp)
EN
15
10.
Rotate the upper hinge 180 degrees
and then unscrew and remove the
hinge pin using a pair of pliers and re-
fit to opposite side of hinge. (8)
11.
Reposition plugs and hinge pin
bushings on top of doors on the
opposite side of both doors. Use
small flat-headed screwdrivers to
remove plugs and bushings. Take
care not to mark doors.(9)
12.
Reposition left hand side feet on
the opposite side. Unscrew and
reposition the bottom hinge bushing.
(10)
13.
Unscrew and remove the upper
door middle hinge pin bushing/
door stopper using a cross-headed
screwdriver. Important: This part
cannot be used on the opposite
side; left hand side middle hinge pin
bushing/door stopper part is supplied
in the plastic bag.(11)
14.
Re-fit the upper hinge on the left hand
side using flat-headed screwdriver.
(12)
15.
Fit upper door left hand side middle
hinge pin bushing/door stopper
supplied in the plastic bag using
cross-headed screwdriver.(13)
16.
Reposition three small plastic plugs
on the left hand side, which are
covering middle hinge holes, on
the opposite side to cover holes left
empty.(14)
17.
Locate and re-fit upper door to upper
hinge and hold the door firmly.(15)
18.
Locate the middle hinge pin to middle
hinge pin bushing of upper door on
the left hand side and re-fit the middle
hinge.(16)
19.
Reposition the two screws fitted to
lower hinge holes on the left hand
side at the bottom of the cabinet on
the opposite side.(17)
20.
Locate and re-fit lower door to middle
hinge pin and then re-fit the lower
hinge on the left hand side.(18), (19)
21.
Carefully stand the appliance upright
and adjust the two front feet if
necessary.
22.
Check that doors open and close
easily, they are aligned correctly and
that there are no gaps allowing air into
the cabinet. If there are gaps between
the door seal and the cabinet, adjust
the door seal by gently pulling away
from the door using fingers.
23.
Check that all the hinge screws are
tightened. Avoid over tightening the
screws.
24.
Put all items, fittings back in the
appliance.
25.
Fit upper door top trim and front top
panel plastic hinge covers. Upper
door top trim hinge covers are
supplied in the plastic bag.(20)
26.
Wait for at least 4 hours to allow the
system to settle before switching on.
27.
Once the correct storage
temperatures have been reached in
the appliance, put back all the food.