![background image](http://html1.mh-extra.com/html/blomberg/fnt-9673-p/fnt-9673-p_operating-instructions-manual_2774000008.webp)
EN
7
3
Installation
Installation Instructions
1.
The space in the room where the
appliance is installed must not be
smaller than 10 cubic metres.
2.
If possible avoid placing the appliance
near cookers, radiators or in direct
sunlight as this will cause the
compressor to run for long periods.
If installed next to a source of heat
or refrigerator, maintain the following
minimum side clearances:
From Cookers 2” (50 mm)
From Radiators 12” (300 mm)
From Refrigerators or Freezers 1”
(25 mm)
3.
Make sure that sufficient room is
provided around the appliance to
ensure free air circulation. Allow a
minimum of 60 mm (2.4 inches)
between the top of the appliance and
the ceiling or the underside of a wall
cupboard.
4.
Fit the two plastic wall spacers
supplied onto the condenser at the
back of the appliance by rotating
them 1/4 turn.
5.
The appliance should be located
on a smooth surface. The two front
feet can be adjusted as required. To
ensure that,your appliance is standing
upright adjust the two front feet by
turning clockwise or anti-clockwise,
until the product is in firm contact with
the floor. Correct adjustment of feet
avoids excessive vibration and noise.
6.
Refer to “Cleaning and Care” section
to prepare your appliance for use.
7.
A special receptacle is supplied to
store the mains plug during transit.
The receptacle is fixed at the back of
the cabinet, on the right hand side of
the compressor. (See diagram) Gently
remove the plug from the receptacle.
Never pull the mains cord, you may
damage the appliance. In the case
of transportation, ensure you locate
the plug in the receptacle provided to
avoid transit damage. transit provided
to avoid transit damage.
Changing the door opening
direction
The door opening direction can be
reversed by authorised personnel
but it is not covered under the
warranty and you are likely to be
charged for this service.