EN
4
Correct use
• This machine is designed solely for
preparing espresso, cappuccino,
long coffee and for boiling water for
tea and other hot drinks. Other types
of use are not permitted and may
prove dangerous. The manufacturer
will not be held liable for any damage
caused by incorrect use of the
machine.
Technical safety
• Before connecting the machine to the
electricity supply, check the electrical
information (voltage and frequency)
on the data sheet with that of the
electricity supply thoroughly.
• This data should be exactly the same
to avoid damaging the machine. In
case of doubt, contact a qualified
electrician.
• The electrical safety of the machine
is only guaranteed if it is connected
to a regulation earth wire. It is very
important to check this carefully. In
case of doubt, have the electricity
supply checked by a qualified
electrician.
• The manufacturer will not be
held liable for any harm or
damage caused due to a lack or
malfunctioning of the earth wire
(e.g.
risk of electric shock)
.
• Only operate the machine when
installed so as to avoid contact with
electric parts. For the assembly,
dismantling and daily maintenance
of the machine, always make sure
it is disconnected from the electrical
supply.
• The machine should not be
connected to the electrical supply
with extension cables, as these do
not provide the necessary safety
for the machine
(e.g. danger of
overheating)
.
• The machine may also be built into a
cabinet (special accessory). It is not
suitable for outdoor use. Due to the
weight of the machine, the cabinet
must be secured firmly to the wall.
• Installation, maintenance and repair
works must only be carried out by
qualified persons. Any installation,
maintenance and repair works
carried out incorrectly may cause
considerable danger to the user,
for which the manufacturer will not
assume any liability.
• The machine should only be
disconnected from the electrical
supply when:
- The main switch of the electrical
supply is disconnected;
- The fuse for the house electrical
supply is removed;
- The plug to the machine is taken
out of the electrical socket. To
disconnect the machine from the
electrical supply, unplug without
pulling on the cable.
“TO REDUCE THE RISK OF INJURY,
DO NOT DRAPE CORD OVER THE
COUNTER TOP OR TABLE TOP
WHERE IT CAN BE PULLED ON
BY CHILDREN OR TRIPPED OVER
UNINTENTIONALLY”
POWER CORD HAS TO BE: UL
approved, type SJO/SJT 16AWGx3C
moulded plug, max length 4-1/2ft
(1.4Mt)