Installation
8
Oven Assembly
CONVEYOR BELT
Be sure to install the belt from left to right. The con-
veyor belt has loops on both sides. The loops must
travel backwards on the conveyor support. See
Figure 8.
Belt Top
Dir
ection
of
C
on
vey
or
Tr
av
el
Figure 8
Unless specified otherwise, conveyor travel is fac-
tory set for left to right operation when facing the
front of the oven. To change direction:
D
Reverse the polarity of the drive motor. Inter-
change the black and white motor leads at the
D.C. controller located in the control panel.
D
Install the conveyor belt from the left side of the
oven.
To thread the conveyor belt
1. Start from the right hand side of the oven, low-
er level first. Unroll the belt as shown in
Figure 9, otherwise the belt will be upside
down. Leave about one foot hanging out on
the left side
NOTE: If belt travel is from left to right, start
from the left side of the oven.
2. Take the remainder of the belt, loop it around
the right shaft. Push through on the upper lev-
el.
3. The two ends of the belt should be approxi-
mately 6-9 inches past the left shaft on the up-
per level of the belt support. Right shaft if right
to left travel is required.
Figure 9
Figure 10