7
Installation
Plumbing Connections
WATER CONNECTION
•
Must meet the requirements applying to water sup
-
plied to household appliances.
Water & drain connections for Mini Hoodini
Figure 2
BLCT-61, 62, 101 & 102 models
•
1 connection for raw water for the quench jet.
• 1 connection for steam generation and the Combi
Wash jet in the oven chamber. Must meet the re-
quirements applying to water supplied to household
appliances.
Quench
Steam
Figure 3
WARNING!!
The water connections must be carried out
by an authorized plumber in accordance with
existing local codes.
Clogged up water filters and dirt in the sole
-
noid valves are not covered by the warranty.
Cold water connection only.
To facilitate cleaning and servicing, the oven should be
connected with an approved flexible 3/4” hose. Perma
-
nent installations should be fitted with a stop-tap and a
non-return valve.
Before connecting the oven to water, flush the tubes
thoroughly. Connect the oven.
DRAIN CONNECTION
Blodgett ovens are equipped with a drain system that re
-
moves surplus water from the oven chamber. This may
be condensed water from the products, or it may occur
when the oven chamber is cooled down with cold water,
or when the oven chamber is cleaned.
NOTE: The drain piping must consist of temperature
resistant material, greater than 160°F, and be
of adequate diameter not to cause flow restric
-
tion. Improper materials may deform and cause
restrictions, thus affecting performance.
External Trap
The oven is provided with an external drain trap. It is
crucial that this part is installed on the oven. If not,
the oven will not function as intended.
WARNING!!
Connection must be carried out by a licensed
plumber, to an open or closed drain. The drain
must never end directly beneath the equip-
ment. The drain should not be located on the
same side the equipment controls are located.
The drain must be of stainless steel or an equally tem
-
perature-resistant material, have a diameter of at least
1.5” (38 mm) and a fall of at least 3° or 5%.
CLEANING CHEMICAL
7. Connect the supplied detergent tubes (red and blue)
to the underside of the oven near the rear. Connect
the blue hose to the fitting with the blue sticker and
the red hose to the fitting with the red sticker.
Red Sticker
Blue Sticker
Red Tube
Connection
Blue Tube
Connection
Figure 4
8. Insert the blue and red hoses into the proper bottles.
Red is for detergent, blue is for rinse aid.
NOTE: If the tube is cut to length, remove the stain-
less steel weight from the end of the tube
and reinsert.