Blocks ONE MKII, User Manual

Page: 53 / 110

USER GUIDE MANUAL DE UTILIZAÇÃO PRO S30 53
Nozzle clearing
Nozzle clogging can occur due to several factors. From contamination with solid particles,
the use of inadequate printing parameters, or even excessive proximity between the plate
and the nozzle may be responsible for the nozzle clogging.
To perform this operation follow the following steps in the order described:
1. With the machine switched on but not printing, select and then .
Put the nozzle at 220ºC and wait until the temperature stabilizes.
2. In the menu select and click to disable the motors.
the opposite direction.
on the opposite side of the insert. This process should be relatively smooth and if you
cannot get the needle through, contact Blocks customer service immediately.
and at the same time relieving the tension of the extruder hinge.
8. Take a piece of PLA with at least 30 cm and repeat step 4 until the plastic exit through
the nozzle is normalized. The plastic outlet should be linear and should not curl.
the nozzle has become unobstructed.
If you did not succeed repeat all the steps above.
If you still do not get good results contact our customer support.
Maintenance
05
05.7