43
First commissioning and installation
After you have safely installed your device and have carried out all the wirings, you can switch on your
BB-200 for the first time. Have your password (WEP or WPA) and if necessary your network identifier (SSID)
ready for a possible WLAN installation. After turning on the BB-200 will start on CD mode.
Please confirm the privacy policy (visit frontiersmart.com/privacy for more information). Please confirm
the question after starting the setup-wizard with “Yes”, press the arrow button of the remote control until
“Yes” appears and confirm with the key “Enter”:
▶
Select your desired time format, either 12 h or 24 h and confirm with the button „Enter“.
▶
Select in the next step „Update from DAB“ (recommended) and confirm.
▶
Every time your BB-200 starts it will in future recover automatically the information to time and date
from this source.
▶
For the following time zone setting, please select UTC +1: 00 for use in Germany. For other locations
please select the appropriate time zone and confirm.
▶
In the following setting, please indicate whether your location currently has summer time, then „ON“
would be the correct option.
▶
In the following query „Keep network connected?“, it should be confirmed with „Yes“ in order to avoid
interruption and streaming problems.
▶
When choosing WLAN region, please choose “Most of Europe”.
▶
Now it starts searching a WLAN connection and shows you all found WLAN networks (SSID) in your
surroundings. Please select „Skip WPS“. Select your WLAN network and enter your password. In case
your WLAN does not appear, this could be due to the following reasons:
▷
WLAN aerial not installed.
▷
WLAN signal too weak at the installation place (perhaps it would be necessary to adjust the aerial to
the router and on the BB-200 or use a WLAN repeater).
▷
WLAN SSID suppressed on the router, select the input “Manual configuration”.
▷
If you connect the BB-200 with an ethernet cable with your router, instead of using WLAN, select
“Cable”.
In case your router supports WPS, select “Press key” and then press the appropriated button on the router.
Alternatively you can also choose “Skip WPS” and subsequently enter the network password (WEP or
WPA). Afterwards, in both cases the device should be finally connected.
Summary of Contents for BB-200
Page 1: ...BB 200 Bedienungsanleitung Manual ...
Page 63: ...63 ...
