Page 6
Big Bad Lo Fo Manual - Rev. A
(c) 2018 Blizzard Lighting, LLC
Automatic Water Injection
You can fill the water tank manually, or connect a water supply directly to the water
inlet located on the side of the machine. Use the supplied nozzle and faucet connec-
tors as needed. If a water supply is connected to the water inlet, the unit will auto-
matically adjust the water level by use of the float switch inside the water tank.
Note:
When filling the tank, the water level needs to be covering the water level
sensors by at least about 3-4 cm. If there is not enough water in the tank, the red
warning LED near the sensors will illuminate. Sporadic fog output, or if the fog itself
is rising too high are also signs of the water level being too low.
Water Drainage
The water tank drainage valve is located on the underside of the unit. Open the valve
to drain the water tank, and be sure to close the valve when draining is complete.
Water Level
Sensor
Remote Control
Start Fog
Increase Fog
Output
Stop Fog
Decrease Fog
Output
