5 - 10 - 15 x 1/1 GN ANALOGIC
13
1.7 ELECTRICAL CONNECTION
When the appliance is delivered it is set to work at the voltage given on the rating plate affixed on the right
side of the appliance.
The terminal board used for connecting can be accessed from the right of the appliance, removing the
side panel.
The effectiveness of the equipotential system of which the
appliance is part of, must conform to current standards.
Connect using the screw you find near t
he power cable’s
relief cable strain, marked with the word
EQUIPOTENTIAL
.
The Manufacturer declines all and every responsibility if this
important accident prevention norm is not complied with.
If the feeding cable is damaged, it must be replaced by the
technical service or in any case by similar qualified person-
nel, in order to avoid any risk.
Before connecting the cable, remove the steel protec-
tion fixed to the ovens base with its specific screws, insert
the cable in the clamp-connector and then in the terminal
board zone, passing through the hole with the gasket near
the terminal board.
Once the electric connection has been carried out, reas-
semble the steel protection previously removed.
The specifications of the flexible cable for the electrical
connection should be no lower than those of the type with
rubber insulation H07 RN-F, with the cross section of the
wires as given in the technical data.
Install upstream a device that can ensure disconnection
from the main, with an opening distance of the contacts,
able to guarantee complete disconnection of the category
overvoltage III, in compliance with installation rules.
It is essential to connect the appliance to an effective earthing system; for this purpose the relative termi-
nal with the symbol to which the earth wire is to be connected is on the terminal board.