IM0001_L2_R_WMv1.3
19
CAUTION:
Be careful to not disturb factory wiring when making supply circuit wiring connections
within the charger housing.
5.
Connect the AC supply conductors (L1 and L2) to the upper two terminals in the terminal block
(Figure 11) at the lower left of the charger assembly.
6.
Connect the ground wire to the service ground terminal (Figure 11) at the lower right of the
charger assembly.
7.
Remove and discard the protective film on the touch screen.
8.
With the service wiring complete, place the housing cover in position on the charger assembly
and install five M6 hex-head bolts (Item 3, Figure 4) to secure the cover in place. Tighten the bolts
to 35-38 in-lb (4.0-4.3 Nm).
9.
Align the pins at the top of the bezel with the two grommets in the charger assembly base plate
and seat the bezel over the housing cover.
Figure 12 – Bezel Installation
10.
Install two Torx-head screws (Item 1, Figure 4) at bottom to secure the bezel to the charger
housing.
Summary of Contents for Wall Mount Charging System
Page 1: ...Wall Mount Charging System Installation Manual Simply Smart ...
Page 28: ......
