12
13
information
i
information
i
User selectable functions
You can customise some of the functions of your pager to suit
your own requirements. This can be done at any time.
The following is a complete list of the functions. You will only
see those functions made available to you when your pager
was configured.
Several functions are set as configuration defaults in the
factory. The headings for these are in normal text. The
remaining functions are shown in italics. The user functions
are shown on the TOP display. The front display will show
the last received message (if any).
To access the selection mode
Press and hold button
until the individual code is
displayed then release it.
Display orientation
Silent mode
Long ID
Bleep volume
Message review method
(select individual) (select block)
Program
If you wish to program an identity code (Individual or
Group) press
and follow the instructions on page 5.
Otherwise allow the pager to continue through the
selection sequence.
User groups
When you have finished your pager will return to normal
operation.
To configure your pager
These procedures allow you to set the engineering functions
of your pager to allow it to operate with your paging system
and to select user functions.
WARNING
If your are not sure how to set these engineering functions
please refer to your supplier. If you make an invalid setting
your pager might not work.
You must delete all identity codes from your pager before you
can change the configuration.
To change the setting of a function
press
whilst it is shown on the
display.
Each time you press the button the
setting will change.
If you do not press the button for a
short while the pager will move to
the next function.
The pager will show the available
functions in sequence.
Press button
ƒ
only if you wish to
make a change.
This inverts the display to make it
easier to read wherever you wear
your pager.
You can stop your pager from
bleeping whilst receiving a call. If
you select SILENT the word will be
displayed alternately with other
active pager functions e.g., RANGE,
LOW BATT.
This selection will lengthen the
bleep period to 24 seconds. You can
still cancel the tone in the normal
way by pressing the message
(bottom) button.
Two bleep volume levels are
available.
This screen will allow you to choose
message review facility. Select a
tick to use BLOCK MESSAGE review
or a cross to review INDIVIDUAL
MESSAGES.
If you switch the pager off it will
revert to the default setting the next
time that it is switched on (the
default is set during pager
configuration - see below).
Programming instructions can be
found on page 7.
This facility allows you to join (or
leave) any of the groups
programmed into your pager. Each
of the programmed groups is
displayed in sequence. Press button
ƒ
to make your choice.
