Blichmann Engineering, LLC 2015
For replacement parts visit blichmannengineering.com/genuine-replacement-parts
7
Caution:
ALWAYS use the washer between the head of the bolt and the tier arm. Failure to use the washer
will cause the bolt to penetrate too deeply into the t-slot and possibly damage the mast extrusion.
Installing the Tiers
Installation of the tiers is done by inserting the t-slot plates into the t-slots of the mast as shown in Fig 16. It is
helpful to have someone assist you in installing them. Position the tier in the desired location and tighten the t-
slot plate bolts slightly so they can be adjusted as needed in the leveling step that follows.
Tip:
The tiers can be installed on all 4 sides of the mast!
As shown in Fig 1
7, use a carpenter’s level and level the burner front to back and side to side. Tightening the
nuts snugly (20 ft-lb or 27 N-m) using a torque wrench.
Caution:
Excessive tightening may permanently deform the mast.
Shelf tiers are installed identically to the burner tiers.
AT THIS TIME FULLY TIGHTEN ALL FASTENERS.
Installing the Fuel Manifold
Fig. 14
Fig. 15
Fig. 16
Fig. 17