Blichmann Engineering, LLC 2015
For replacement parts visit blichmannengineering.com/genuine-replacement-parts
10
Figs 25, 26, and 27 show close-up views of a middle tier gas connection, upper tier connection with plug, and
the regulator connection to the manifold respectively. Fig 28 shows how to route piping to reach the flex hose
if your manifold is on the opposite side of your burner tier. You will need to purchase (2) 2” nipples, (1) 90 deg
elbow, and a pipe coupling to complete this piping. These parts are not included with the product, but are
readily available at any hardware store or home improvement center.
This concludes assembly of the TopTier brew stand. Note that you can easily reconfigure your stand at any
time, or partially disassemble for transport or storage!!
Fig. 23
Tighten this nut after installing on mast
Thread square nut flush
with bottom of bolt
Fig. 24
P-clip assembly
Fig. 26
Fig. 25
Fig. 28
Fig. 27
Use plug to cap off the upper tier
Close-up of typical tier connection.