BLEMO ER41, Manual

Page: 123 / 126

123
ER41, ER24
Glossary
A
Abbreviations
Req. = Required
Opt. = Optional
D
Display terminal
The display terminal menus are shown in square brackets.
For example: [Communication]
The codes are shown in round brackets.
For example: ( )
Parameter names are displayed on the display terminal in square brackets.
For example: [Fallback Speed]
Parameter codes are displayed in round brackets.
For example: ( )
E
Error
Discrepancy between a detected (computed, measured, or signaled) value or condition and the specified
or theoretically correct value or condition.
F
Factory setting
Fault
Fault Reset
Factory settings when the product is shipped
Fault is an operating state. If the monitoring functions detect an error, a transition to this operating state is
triggered, depending on the error class. A "Fault reset" is required to exit this operating state after the
cause of the detected error has been removed. Further information can be found in the pertinent standards
such as IEC 61800-7, ODVA Common Industrial Protocol (CIP).
A function used to restore the drive to an operational state after a detected error is cleared by removing
the cause of the error so that the error is no longer active.
M
Monitoring function
Monitoring functions acquire a value continuously or cyclically (for example, by measuring) in order to
check whether it is within permissible limits. Monitoring functions are used for error detection.
P
Parameter
PELV
PLC
Device data and values that can be read and set (to a certain extent) by the user.
Protective Extra Low Voltage, low voltage with isolation. For more information: IEC 60364-4-41
Programmable logic controller