To change the MIDI input channel, have plug in the input jack. Same for output, even if you’re using USB MIDI.
CV input modes
FM – bipolar (-5V to +5V) CV modulates frequency.
Direct to LED – bipolar level is seen on LED
Voice Mode – voice is selected based on 0-5V signal coming in.
voice adjust – Defualt mode. Voice adjustment is modulated by incoming bipolar signal.
LEDacle mode – LEDacle mode is selected based on 0-5V signal coming in.
LEDacle Adjust – LEDacle rate is modulated by incoming bipolar signal.
E ect mode – E ect mode is selected based on 0-5V signal coming in.
E ect Adjust – E ect adjust is controlled by incoming bipolar signal.
CV output modes. All 0-5V
Eye photocell level (default)
Inverted eye photocell level – Fully dark would give 5V.
LED level out
Inverted led out
BLEEP button trigger out – 5V when the bleep button is active, 0V when o .
Option mode
To change the MIDI input and output channels as well as CV modes hold down the small button on top
of the device for 2 seconds. The LEDacle will then blink dimly and the three knobs will allow you select
variables as shown. Press the top button again to go back to normal.
