7 |
BLAZE OUTDOOR PRODUCTS
USER MANUAL |
8
Install the two grease trays in the frontand back of the
unit When installed, these trays will accept the
grease filters on the bottom side The front grease tray
will provide a barrier between the filters and the
control knob connections The rear grease trays
install in the rear channel at the back of the unit
Note:
When installing the drip trays, place each tray in
the opening at the front and rear as shown in the drawing
Be sure to have the small front bend hook over the
lip of the opening
step 5
Electrical Requirements -
Hood comes with 4 foot cord, and will plug into a 110V outlet
which should be wired to a 15 AMP breaker
wall hood installation
Motor Rotation Instructions
Getting Started
The image to the right shows the position of the motors directly from
the factory This position of the motor is used when running vertical
pipe for your venting
Step 1: Remove Cover Plate
There are two sets of screws you will be working with on the cover
plate The smaller screws closest to the edges of the plate hold the plate
to the hood itself The larger screws closer to the center hold the motor
to the cover plate Remove all of the smaller screws holding the cover
plate to the hood body
Step 2: Remove Motor Screws
Next, remove all of the larger screws that hold the motor to the cover
plate leaving the center screw The center screw to be left in place can
be seen in the image
Step 3: Detach motor from plate
Holding the center of the motor, remove the final screw, which will free
the motor from the cover plate Lower the motor gently until it comes
to resting position
Step 4: Rotate Motor
At this point, the cover piece can be removed and you are ready to
rotate the motor to the horizontal discharge position When lifting the
motor out of the housing, tilting the motor down on one side is typi-
cally the best method for getting the motor out of the opening
Once out of the hood, simply rotate 180 degrees and place the mo-
tor back into the hood For both the removal and reinstallation of the
motor, be careful not to pinch the wiring Allow it to rest at the initial
position when you started
Step 5: Replace the Cover PLate
Next, re-install the cover plate with the discharge in the hori-
zontal position The cover plate can be reattached with the small
screws
Re-attach the motor to the cover plate Start with the center screw,
which was the last screw removed when the motor was disattached
Once the initial scerw is in place, attach the remaining screws to
hold the motor onto the cover plate
Step 6: attach the motor
Step 7: Secure loose cables
You will find some of the connecting cables now lying below the motor Secure wires above motor
and the rotation process is complete Repeat same process for additional motor
Install all grease filter handles to the filters
using the included screws Three filters cover
the front section of the hood and three cover
the back Install the filters leaving the bottom
of the filters resting in the previously installed
grease trays and the tops will lay in the U
shaped channel in the center support All
filters must be installed from the center posi-
tion, and then moved to the left and right,
leaving the center positioned filter for last
step 4
Secure the bottom of the vent hood to the wall Using a
power drill, drill a hole at the stud location through the
vent hood’s rear wall at the lower left and right side Secure
the appropriate screw for the material you are mounting
to ( not provided ) through the holes with the appropriate
screws and into the stud in the wall
step 6
