Press & hold setting button to enter
setting interface.
Press setting button twice, P3 will be
shown.
Press OK button, then press the setting
button to switch between thresold value
interface
(High Pressure Value & Low
Pressure Value )
. Select the preferred
interface by pressing OK button. The
digit will flash then press the setting
button to adjust the preferred value &
press OK button to select.
High Pressure Value Setting Interface
Thresold Value Setting
a)
b)
c)
•
• External sensor
- Disassemble the external sensor from
the front left tire & reinstalled, for
sensor ID pairing activation.
• Valve sensor
- Releasing the air from tire continously
instead of intermittently, ensure that
the releasing process is not less than
8 second.
- Do not exceed the maximum pressure
of tire during inflating.
When system receives the signal, you
will hear “
Di-
” which indicates successful
sensor pairing (new sensor ID will be
displayed). Then, it will continue to
next order.
d)
e)
Di-
Sensor Pairing Setting
(It is required only when the sensors has
switched location or be replaced)
a)
b)
c)
Press & hold setting button to enter
setting interface.
After entering the setting interface,
P1 will be shown.
Press OK button to enter pairing mode.
Press the setting button to switch the
preferred position, press OK button to
select. Press & hold setting button again
to return back to the first pairing order.
(Pairing order : Front Left > Front Right >
Rear Right > Rear Left)
Di-
Di-
Tire Position Exchange Setting
(It is required only when the tires has switched
location)
a)
b)
c)
d)
Press & hold setting button to enter
setting interface.
Press setting button again, P2 will be
shown.
Press OK button, the digits on the top left
& top right will flash. Press the setting
button again to switch preferred position,
press OK button to select. You will hear
“
Di- Di-
” which indicates successful.
Press & hold the setting button to exit
setting interface.
2.
1.
SETTING
SETTING
9
10
•
•
Ensure that there is only one of the tire with
sensor is activated during pairing, otherwise
there is no guarantee that the sensor ID that really
needs to be paired will be paired into the receiver.
To cancel the current pairing process by pressing
return key, however pairing process cannot be
canceled after prairing process is successful.
