40
FITTING
Handling new discs with uneven
edges
• The inner and outer edges of a new
disc may not be perfectly smooth.
• When a disc with uneven edges is
inserted, it may not locate correctly,
making it impossible to play.
• Correct these uneven locations be-
fore inserting the disc using a pencil
or ballpoint pen, as shown here, by
running the implement over the in-
ner and outer edges of the disc.
Note:
• Choose a location to fit the equipment
where it will not interfere with the
driver’s ability to control the vehicle.
• Before fitting the equipment into the
vehicle, temporarily connect the ca-
bles and check that all the connec-
tors mate properly and that the equip-
ment and the system operate cor-
rectly.
• To ensure correct fitting, only use the
parts supplied with the equipment.
The use of non-approved parts can
cause incorrect function.
• If fitting requires holes to be drilled
or other modifications to be made to
the vehicle, take it to a qualified work-
shop near you.
• Fit the equipment in a location that
will not interfere with the driver, and
where the occupants of the vehicle
will not be put at risk by an abrupt
stop, such as hard emergency brak-
ing.
• If the equipment is fitted as an angle
more than 30
°
to the horizontal per-
formance may deteriorate.
30
• Avoid fitting the equipment at loca-
tions where the ambient temperature
is raised by, for instance, direct sun-
shine or the car’s heating system.
Avoid locations where the equipment
would be exposed to dust, dirt or
heavy vibration.
Rough points on
the outer edge
Ballpoint pen
or pencil
Rough points on
the inner edge
ABOUT DISCS