Blaupunkt IM715, Owner'S Manual

Page: 5 / 54

Device is compliant with EU directives:
- Low voltage directive (LVD)
- Electromagnetic compatibility (EMC)
Device marked CE mark on rating label
When this crossed-out wheeled bin symbol is attached to a product it means that the
product is covered by the European Directive 2012/19/EU. Please inform yourself about the
local separate collection system for electrical and electronic products. Used appliance
should be delivered to the dedicated collecting points due to hazardous components,
which may affect the environment. Do not dispose this appliance In the common waste bin.
Environmental informationAll unnecessary packaging has been omitted. We have tried to
make the packaging easy to separate into three materials: cardboard (box), polystyrene
foam (buffer) and poly ethylene (bags, protective foam sheet). Your system consists of
material which can be recycled and reused if disassembled by a specialized company.
Please observe the local regulations regarding the disposal of packaging materials,
exhausted batteries and old equipment.
Your products is designed a manufactured with high quality materials and components,
which can be recycled and reused.
PREPARING THE MATTRESS
Unroll the mattress and lay it on a clean flat surface.
To inflate the mattress with air, close the side valve. Remove the power cord from the compartment,
plug the power cord plug into the power source outlet. Switch the pump knob to the "inflate" position.
The pump will start working to inflate the mattress. When the mattress is sufficiently inflated, turn the
pump off by turning the knob to the "off" position. Disconnect the power cord from the power source
and put it in the compartment. Do not use the mattress when the pump is connected to the power
source.
STORING THE MATTRESS
After use, drain the air from the mattress. To do this, open the valves, and gently fold the mattress by
pressing it.
You can also use a pump to pump out the air. To do this, connect it to a power source, set it to the
"deflate" position.
Store the folded mattress in a dry place.
R EPAIRING A MATTRESS LEAK
If a mattress leak is found, inflate the mattress. Locate the suspected location of the air leak by
listening. Gently moisten the suspected area with soapy water. At the location of the air leak, bubbles
would appear.
Empty the mattress of air, clean and degrease the area around the leak well. Apply an appropriately
sized patch at the air leak site. Smooth it out. Leave the patch pinched with a heavier object for 24
hours to dry.
TECHNICAL PARAMETERS
Power supply: 220-240 V~50 Hz,140 W
Material: PVC, velour
3
IM715/720/820